Sunday, October 13, 2019

Gravity-Centrifugal-Power-Motor :: essays research papers

SCM-Variation Gravity-Centrifugal-Power-Motor Objectives At chapter Swing-Circuit-Motor (SCM) above, a design was worked out corresponding to build-up of a loop-swing. There, two axis were demanded (system- and excenter-axis) and two  ´wheels ´ did turn within each other. So this will be a rather difficult technical construction. By this chapter now shall be examined, how effect of building-up mechancal oscillations could be realized easier. So only one axis should be neccessary, nevertheless masses should move like at uneven  ´movement of pendulum ´, above this phase shifting by intermediate storage of forces must be guaranteed. Pendulum with radial suspension At previous chapter Mechanical Oscillating Circuit Harald Chmela did mention example of a pendulum with radially working spring, like schematically shown once more at picture EV SKM 31 upside. Around system axis (SA) a pendulum, here called rotor arm (RT, German Rotortrà ¤ger), can swing. At the rotor arm effective mass (MP) can glide inside and outside. That radial movements are limited resp. controlled by a spring element (FE, German Federelement). Potential energy of level is transformed into kinetic energy at downward-phase, opposite energy of movement is re-transformed into energy of high level at upward-phase. In addition, power is stored into spring intermediately, so some later power is restored into pendulums oscillation. Mass will move at an U-shaped track. Mass will show maximum speed at its lowest point of track (A) and there will press down spring at its maximum. Following relaxation of spring will show analog relations of forces, based at symmetry, so this mechanical oscillation will be stable (no friction assumed). Effect of building-up oscillations can only be achieved, if symmetry is broken. This could be done e.g. as shown at picture EV SKM 31 downside. Asymmetric track Tension of spring downside should have to be stored for a short time, e.g. any mechanicsm could allow relaxation of spring some later (B). Counter stored energy then would exist less forces (resulting force of gravity power and centrifugal power), showing upward more and more. Power of spring afterward could move mass easier and faster towards upward-inside (C). Angles speed thus will be accelerated and mass will be brought to higher level (D) than starting level. This mechanical oscillating circuit thus will be build-up without input of energy from outside. Progressive suspension By this concept an asymmetric track is achieved. However, this pendulum swinging resp. effect of build-up oscillations is technically usable only if a momentum is achieved at a constant turning shaft.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.